Belt and Deck Lubrication Procedure According to Sole and Spirit W/ Engineering Mode Instructions

Jul 10, 2020

The belt & deck come pre-lubricated and subsequent lubrication should be performed every 180 hours or if you notice that the deck is dry. It is recommended that you reach between the belt and deck to verify there is lubrication present, every other month. If you check and there isn't any lubrication present, follow the procedure below evne though the "Lube" indicator isn't lit on the console. Otherwise, lubricate when the console's lubrication reminder lights after 180 hours of use.

Use the following procedure to apply the silicone lubricant:

1. Turn the power switch off and unplug the power cord from the wall outlet

2. Measure 18" from the edge of the motor cover; kneel down and reach under the belt approximatelt 4-6" from one edge. Squirt a line of lubricant about 1/8" wide x 15" long in an "S" pattern perpendicular to the motor cover (see Figures 1 & 2 above).

3. Repeat the process on the opposite side.

4. Plug the electrical cord back into the outlet and turn the power switch on.

5. Walk on the belt at a moderate speed for five minutes to evenly distribute the silicone lube.

6. Note: If the "Lube" message appears on the console, perform the following procedure to reset the message:

      a.  To enter the Engineering Mode Menu press and hold down the Start, Stop and Enter keys, then at the same time insert the safety key. Keep holding the keys down until the Message Center displays Engineering Mode  Menu. Press the Enter button to access.

      b. Press the Speed+ button (or Speed - button to go backwards) until "Functions" appears; press Enter 

      c.  Press the Speed+ button until "Reset Lube" message appears, press Enter

      d.  Press Stop to exit engineering mode and resume use of your treadmill